IGP-KORROPRIMER 6007A-V0
The powder coating primer for aluminum and steel with good UV resistance, which harmonizes perfectly with IGP powder coatings for facades.
download PDFCharacteristics
- Silk gloss
- Smooth finish
- Uni colors
- Industrial outdoor quality
- Degassing optim.
Powder properties
Film properties
Processing
The substrate must be free from oil, grease and oxidation products. The pretreatment depends on the type of substrate and the corrosion protection to be achieved. We recommend the following pretreatments:
- Chrome-free pretreatment according to GSB International and QUALICOAT specifications
- Chromating according to DIN EN 12487
- Pre-anodization
- Blasting: Electro corundum or conditioned cut wire shot should be used. After blasting, the norm purity degree must be at least SA 2 ½ (white metallic polish) in accordance with DIN EN ISO 12944-4. Further details can be found in this norm. Sharp edges, overlaps, etc., should be avoided (see EN ISO 12944-3).
- Zinc phosphating
- Chrome (III) passivation
- Chromating according to DIN EN 12487
The suitability of the pretreatment method used is generally to be tested by the coater in advance with appropriate test methods. The minimum requirement for aluminum substrates / galvanized steel components is to carry out a boiling water test with a subsequent cross-cut adhesion and tape test. We refer to the guidelines of the GSB International, Qualicoat and Qualisteelcoat certifications. For further information: see also our special leaflet on pre-treatment (IGP-TI 100).
TObject | t min | t max |
---|---|---|
338 °F | 15 minutes | 20 minutes |
356 °F | 10 minutes | 15 minutes |
374 °F | 8 minutes | 12 minutes |
More information
Consult the Safety Data Sheet prior to use.