IGP-HWFclassic 592SC-A8 LivingSurfaces
Silk-matt powder coating with wave-like coarse structure and unicolored speckles based on saturated polyester, highly weather-resistant, for stoving conditions from 20' 170° C.
download PDFCharacteristics
- Silk gloss
- Coarse texture
- Spotted effect
- Super durable façade quality, 3 years Florida > 50% residual gloss
Material approvals
- Qualicoat Nr. P-1262, class 2
Powder properties
Film properties
Processing
For this product, a substrate-specific pretreatment and corresponding primer application is highly recommended. The results of a single-layer application are the user’s sole responsibility.
- Chromating according to DIN EN 12487
- Chrome-free pretreatment according to GSB International and QUALICOAT specifications
- Pre-anodization
- Zinc phosphating
- Zinc phosphating
- Chrome (III) passivation
- Chromating according to DIN EN 12487
The suitability of the pretreatment method used is generally to be tested by the coater in advance with appropriate test methods. The minimum requirement for aluminum substrates / galvanized steel components is to carry out a boiling water test with a subsequent cross-cut adhesion and tape test. We refer to the guidelines of the GSB International, Qualicoat and Qualisteelcoat certifications. For further information: see also our special leaflet on pre-treatment (IGP-TI 100).
For the application IGP-HWFclassic 592S...A81 on aluminium, the use of a colour-similar highly weather-resistant fine structure as a primer, either IG-HWFclassic 591TA...R10 or also 591TC...A11 in a minimum layer thickness of 60 μm is recommended.
In this case, the minimum layer thickness of the Top-Coat
592S..A81 may be less than 130 μm after testing.
The processing guidelines (VR 213) must additionally be observed.
Steel substrate:
For the application of IGP-HWFclassic 592S...A81 on bare steel or galvanised steel, the use of the corrosion protection primer IGP-KORROPRIMER 60 in a minimum layer thickness of 80 μm is mandatory.
For the application of IGP-KORROPRIMER 60, please refer to the technical data sheet IGP-KORROPRIMER 60 and additionally the processing guidelines (VR 213) must be observed.
TObject | t min | t max |
---|---|---|
338 °F | 20 minutes | 30 minutes |
356 °F | 15 minutes | 25 minutes |
374 °F | 10 minutes | 20 minutes |
More information
Consult the Safety Data Sheet prior to use.